Product is sold out and is NOT expected to be in stock again. Show similar products
Back |
Dakine backpack

Dakine Circle Mat

EUR 11,95
Item sold out. Can not be delivered
Show similar products
From same brand

An accessory you install between your bindings on the snowboard, so your back foot does not slip when not in the binding i.e. when getting on the lift.

This stomp is made of molded urethane. Therefor it is light weight and easy to work with.

For optimum bonding, make sure that both board and stomp are at room temperature, clean all surfaces with rubbing alcohol. When ready - Heat up the the prepared board surface with a hair dryer on the highest setting, along with the adhesive on the stomp. Immediately after heating - Place the stomp and press it down firmly. Stand on it without twisting about - The more weight the better. Allow the bond to cure at room temperature for 24 hours.